|
备用监控器用来监测不正常波形
适用于检测电力下降，过电压，过电流，冲击，畸变，谐波，和频率波动
打印出波形和分析数据
数据记录功能（增强型）
远距离控制功能
技术指标
基本型
364001：单相AC电压监控器（量程100 V，200 V和400 V量程）
364002：单相电压和电流监控器（量程100V，200V，400V以及1A，5A，10A(使用CT夹钳)）
364003：三相AC电压监（量程100V，200V，和400V）
增强型
364011：单相AC电压监控器（量程100V，200V和400V）
可测频率波动,波形比较,畸变系数和谐波
364012：单相电压和电流监控（量程100V，200V，400V以及1A，5A，10A(使用CT夹钳)）
可测频率变动,波形比较,畸变系数和谐波
364013：三相AC电压监控器（量程100V，200V和400V）
可测频率波动,波形比较,畸变系数和谐波
冲击探测功能：
最大可测值：200V DC，600V峰值500VDC，1200V峰值
内置打印机,触点输出,时钟(带日历功能)
电源故障补偿(备有锂蓄电池当电源故障时保存数据1小时)
电源：100V AC(85-132V)，50/60Hz(48-63Hz)
功耗：150 VA（最大值）
外型尺寸：约260(宽)×199(高)×400(深)mm
重量：约11公斤
工作温度和湿度：00 -400C，相对湿度30%-85%（不冷凝）
| ModelNo. |
364022 |
364023 |
|
| lnput element |
Voltge |
1ch |
3 ch |
| Current |
1 ch |
------ |
| Mea-sure ment range(erest factor2.5) |
Voltage |
120 VAC(50 Hz/60Hz)
240 VAC(50 Hz/60 Hz)
480 VAC (50 Hz/60 Hz) |
| Currert |
1AAC(50 Hz/60 Hz)
5 AAC(50 Hz/60 Hz)
10 AAC(50 Hz/60 Hz)
50 AAC(50Hz/60 Hz) |
----- |
| Ampli-tude of wave-form |
Voltage |
?
24mm for rated input ,10 mm(200V DC) or 5mm(500 V DC)in the mode dedicated to impulse |
| Current |
24mm for rated input |
| Inputburden (PT/Clamp CT) |
Voltage |
[120V range]Less than 0.03VA;typically 0.015 VA
[240V range]Less than0.10VA;typically 0.05 VA
[480V range]Less than 0.40 VA;typically 0.20 VA |
| Current |
[1A range]0.1 mVA or oess |
| Maxi-muminput range |
Voltage |
500V AC continuous(common to each range)
1500 Vpeak (pulse width,1 msor less;duty ratio,less than 1%) |
| Current |
100A AC continuous |
| Maximum continuousin-phase voltage |
500 Vrms |
|
| Upper voltage limit |
[120 V range]54 to 140 V AC,OFF(2 V step)
[240 V range]108 to 280 V AC,OFF(4V step)
[480 V range]216 to 500 V AC,OFF(8 V step) |
| Lowervoltage limit |
[120 V range]44 to 126V AC,OFF(2 V step)
[240 V range]88 to 252 V AC,OFF(4 V step)
[480V range]176 to 500 V AC,OFF(8 V step) |
| Impulse |
[120 V range]50/100/200/500VDC,OFF
[240 V range]50/100/200/500VDC,OFF
[480V range]100/200/500VDC,OFF
*Selection of this value changes the mode tothe one dedicated to impulse |
| Over-current |
[1 A range]0.1 to 2 A AC OFF,(0.1 A step )
[5 A range]0.5 to 10A AC OFF,(0.5A step )
[10 A range]1 to 20A AC OFF,(1 A step )
[50 A range]5 to100A AC OFF,(5 A step ) |
------- |
| Waveform compauison (with the waveformmeasured one cycle before) |
±2 to 20% ofthe meawurement range and OFF (2% step),(voltage only) |
| FrequencyDisplacement |
±5 Hz(0.1 Hz step )of themeasurement range (voltage only) |
| Distoutionfactor |
1% to 50%,OFF(1% step) |
| Harmonics |
Starrup order: Selected ruon the third ,rirgy ,seveenth,ninth ,and eleenthharmonics.
Startup setting:
1% to 20%(1% step )
20% to 50%(5%step )
50% to 100%(10% step) off |
- Detection/Recording Accuracy (within one year after calibration)
|
| Voltage |
±(20%of rdg +2% of range) |
| Impulse |
[120 V range]±(10% ofrdg +3 V)
[240 V range]±(10% ofrdg +6 V)
[480V range]±(10% ofrdg +6 V)
(At pulse width of 100μs or more)
Withoutincluding the mode dedicated to impulse |
| Current |
±(2% of range) |
---- |
| Harmonics analysis |
Computationerror:±0.3%;measurement error:±0.5% of range(though imput harmonecs componentsare linited to 4 kHz) |
| Frequency |
±0.05 Hz |
| Distortionfactor |
±(0.5% of range) |
| Activepower |
±(0.5% of range) |
----- |
| Powerfactor |
±0.05 |
|
